// capabilities

Built to build.

The engineering talent and physical infrastructure to take a wireless product from concept to field-ready.

// the rf lab · fort mill, sc

Inside the lab.

Our facility is outfitted specifically for wireless hardware development: VNAs, spectrum analyzers, vector signal generators, calibrated antennas, and shielded test space.

TWS RF lab in Fort Mill, South Carolina (1)

TWS RF lab in Fort Mill, South Carolina (2)

TWS RF lab in Fort Mill, South Carolina (3)

TWS RF lab in Fort Mill, South Carolina (4)

TWS RF lab in Fort Mill, South Carolina (5)

TWS RF lab in Fort Mill, South Carolina (6)

TWS RF lab in Fort Mill, South Carolina (7)

TWS RF lab in Fort Mill, South Carolina (8)

Wireless Hardware Development

TWS designs and builds custom wireless hardware from the ground up. Our engineers have shipped products spanning embedded firmware, custom RF front ends, and full system integration. If the generic solution is too expensive, too complex, or doesn't exist yet, we build it.

Custom RF front end design
Embedded firmware and DSP
Microcontroller and FPGA integration
Board-level hardware design
System integration and field validation

Tell us your problem →

Wireless Standards and Modem Design

Building a wireless modem or embedded radio to a specific standard requires deep knowledge of both the RF layer and the protocol stack. TWS engineers have done this in defense and commercial applications. We bring that experience to customers who need a purpose-built solution at a fraction of the cost of a generic platform.

802.11, 802.16, and proprietary protocol design
Software-defined radio architecture
Point-to-point and mesh network design
Cost-optimized hardware partitioning
End-to-end encryption integration

Tell us your problem →